PDA

View Full Version : DIY LED - no ligt on Driver 2



TorbenM
02.05.2012, 17:16
Hi

I have two MEAN WELL ELN-60-48D drivers and both are controling 13 Creed LED
I have a GHL proflux II Plus computer to control them

I have connected the drivers to a EVG-AP-2F-HIC ( PL-0556 ) unit


This is how i connected them:

Driver 1: to EVG 1 power supply ballast 1 and ballast 1

Driver 2 : Power supply 2 and Ballast 2

Main power supply: 220v directky from the powerplug in the wall.

When i turn on the Driver-1 on i can hear a "clik" from the EVG-AP and there are lights and i can turn down the light
When i turn on the Driver-2 on i can hear a "clik" agin but no light.

But if i switch so 2 goes to 1 and 1 goes to 2 there is the same problem. no light in ballast 1

I don't use ground wires only + and - wires.

Matthias
03.05.2012, 07:47
so the problem moves with the ballast? if yes:

EVG-AP works
ballast is defective

TorbenM
03.05.2012, 09:32
The problem stays, so the problem have to be with the EVG-AP

Matthias
03.05.2012, 13:01
I understood your post in a way that the problem moves with the ballast

if this was not the case then the EVG-AP may be defective

ask your retailer for details how to handle this

TorbenM
03.05.2012, 14:19
they told my to ship it to you. i bought it at http://www.shop-meeresaquaristik.de/

TorbenM
09.05.2012, 09:16
so? what do I do?

GHL Support
09.05.2012, 14:12
I've sent you a PM.