Matthias
21.04.2012, 17:16
In 5.12 the concept of the manual override of the sockets had been changed: Now single sockets can be switched manually while others remain in automatic mode.
One of the reasons to change this was the new webinterface which is in development and will come very soon.
This new concept unfortunately produced compatibility issues with ProfiLuxControl and ProfiLux, but these updates solve the problem:
- Firmware 5.12b for ProfiLux 3
- ProfiLuxControl 5.1.2.5
- Firmware 1.03 for ProfiLux Touch
all updates are available from now on here:
http://support.aquariumcomputer.com/english/sections.php
I couldn't find any compatibility issues in our test systems here after doing all 3 updates
-> if you have a problem with the manual override then you should do these 3 updates
One of the reasons to change this was the new webinterface which is in development and will come very soon.
This new concept unfortunately produced compatibility issues with ProfiLuxControl and ProfiLux, but these updates solve the problem:
- Firmware 5.12b for ProfiLux 3
- ProfiLuxControl 5.1.2.5
- Firmware 1.03 for ProfiLux Touch
all updates are available from now on here:
http://support.aquariumcomputer.com/english/sections.php
I couldn't find any compatibility issues in our test systems here after doing all 3 updates
-> if you have a problem with the manual override then you should do these 3 updates