CaptCrash
29.03.2012, 18:10
Should the Manual Control on the Touch operate or is it waiting on future firmware like multiple feed pauses?
What I mean is that in the manual control section of the touch, lightning bolts appear or not depending on the sockets status, however if I press the socket, nothing happens. The same situation occurs with the illumination channels, they show the lights status/%, but do not respond to being pressed.
My equipment is as follows
PIII Ex with firmware 5.11
Touch has firmware 1.02
PCL 5.1.1.3 used to configure it.
The only thing that I can see that is odd, is that in the system report within PCL it shows the touch having firmware 1.06 and a powerbar as 1.02. I have assumed that this is an error in PCL but it may be relevant. I have attached the 2384 in case it is useful.
thanks in advance
What I mean is that in the manual control section of the touch, lightning bolts appear or not depending on the sockets status, however if I press the socket, nothing happens. The same situation occurs with the illumination channels, they show the lights status/%, but do not respond to being pressed.
My equipment is as follows
PIII Ex with firmware 5.11
Touch has firmware 1.02
PCL 5.1.1.3 used to configure it.
The only thing that I can see that is odd, is that in the system report within PCL it shows the touch having firmware 1.06 and a powerbar as 1.02. I have assumed that this is an error in PCL but it may be relevant. I have attached the 2384 in case it is useful.
thanks in advance