Assigning numbers to powerbar sockets

[Matthias]

this was a question via PM to me:
(please don't ask for support over PM!!!)

Hello Matthias - Sorry to PM you on this subject, but I can't seem to find an answer for my question on the Forum, and I know that you will be able to assist me.
I have a Profilux III eX and today I purchased a second Powerbar6D-D unit. The first Powerbar is plugged into S1-S4 on the Profilux, and all 6 Sockets worked fine. I then connected the Second new Powerbar6D-D to the first one using the comms cable supplied with the unit, and also connected it to a Power Source. I then unplugged the comms cable for the first Powerbar6D-D and tried to re-program the Sockets for the Second new Powerbar6D-D unit as Sockets 7 to 12. After that, I powered up both Powerbar6D-D units, but I can't seem to get the Socket numbers correct for the second Powerbar6D-D unit. Could you please advise me as to how I should best resolve this problem. Much appreciated. - Regards xxxxxx

[Matthias]

so far this was OK what you have already done, it should work correctly

please try to switch the sockets 1 - 12 manually with ProfiLuxControl in order to see which socket reacts to which channel