Connecting Meanwell Elan60-48D to Profilux 3

[ivolach]

How can I connect 4 Meanwell 60-48D (dimmable) led drivers to Profilux 3.
Specifically:
1. How do I connect the dimming wires to the L ports?
2. Do I need to connect the drivers main power supply to switched ports on Profilux?
3. How many of these drivers can I connect to one L port?

These questions may have been answered before but I am still a little confused and would appreciate clarifications.

Thanks,

[PIWAWT]

You can connect 1-10V directly to PL here (http://support.aquariumcomputer.com/downloads/Manual_EVG-AP2_V400.pdf) are the Information to coonect with the right pins.
Page2
Control line from
aquarium computer
6 5 4 3 2 1
You can connect 2 drivers/L-Port

Pin1 = PL-Dimming 1 + to 1st driver 1-10V+
Pin3= GND or 1-10V - for both drivers
Pin5 = PL-Dimming 2 + to 2nd driver 1-10V+

[ivolach]

Thank you, now it is clear.

How many PNL60-48D can I connect to each dimming channel?

[PIWAWT]

I'm not sure but I think the L-ports operate at 10 or 20 mA. I did not found Informations about this problem on the Meanwell Webpage. I would max. 1 driver per port dimmable take. Another thing is, you have no power off function.

[ivolach]

Thank you.

[Blahenazo]

its idd around 2 per port , 3 would be pushing it ( if you search on the forum you will find it )