View Full Version : Moon Phase - Simul L
freemchr
30.06.2009, 13:58
For some reason my moon phase is not working anymore.
I have the Simul L connected and the blue / white LED is connected to L1 / L3.
In my schedules I have the following:
Illumination 1
10:00pm - Duration 5 - Brightness 5%
4:30am - Duration 5 - Brightness 0%
Illumination 3
10:00pm - Duration 5 - Brightness 5%
4:30am - Duration 5 - Brightness 0%
I then have the moonphase set to operate on L1 and L3 channels.
Start Time : 10:00pm
End Time : 4:30am
Have I done something incorrect?
freemchr
30.06.2009, 14:04
I set the brightness to 10% and the lights turned on.. what is the recommended brightness?
Matthias
30.06.2009, 16:28
I think it is better to adjust the 1-10V interface.
You are writing "L1/L3" - do you have 2 Simus? Or was this a typo error?
Anyway, you should increase the lower voltage of the 1-10V interface we are talking about to a level where the lamp starts, e.g. 2V. You can test this with "manual illumination" on the device directly or "light scenarious" in ProfiluxControl
freemchr
01.07.2009, 00:41
Yes have two sets of Simul L's (4) and 4 T5's connected via Splitters to the 1-10v interface. Currently my 4 T5's and the Simul L's are connected via the interface.
The tank is 10ft.
How do i increase the voltage on the 1-10v interface?
freemchr
01.07.2009, 01:17
Thanks Matthias. Managed to figure it out. Set the Brightness to 1% and will let the Moon Cycle adjust accordingly. Had to set the output to 2v.
freemchr
01.07.2009, 13:12
Ok something isn't right.
Went to manual illumination through the lightmixer can set L1 or L3 to 1% and the lights fire up.
However in my illumination settings:
Illumination 1
10:00pm - Duration 5 - Brightness 1%
4:30am - Duration 5 - Brightness 0%
Illumination 3
10:00pm - Duration 5 - Brightness 1%
4:30am - Duration 5 - Brightness 0%
Nothing is on.
Moonphase is set to:
Start Time : 10:00pm
End Time : 4:30am
And is aparrently on 51% but no light at all through channels L1 and L2.
1-10v Interface L1 is set to U.min 2v U.max 10v
and Interface L3 is set to the same - U.min 2v U.max 10v
freemchr
01.07.2009, 13:16
To add to this, the lights only seem to come on when the brightness is set to 5%. However will turn on through the Lightmixer at 1%.
freemchr
01.07.2009, 14:58
Do I need to set the brightness to 100%?
Matthias
01.07.2009, 16:53
brightness 1% is too less
freemchr
02.07.2009, 00:44
what do you recommend? 30%?
Matthias
02.07.2009, 07:54
whatever you want, but more than 1%
play with the settings until you found what you were expecting
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.