BigAl07
31.12.2011, 00:04
I'm wondering if anyone else is experiencing this problem. I'm posting this for a user on another forum but I've experienced the exact same problem:
Hello,
I recently purchased P3 eX, connected it via usb and now using the pc software. The thing is that when I click on a section (e.g. sensors) and then click on another section I get 2-3 sec lag until it opens it. After that I get no lag but if I do it for the first time in the current profilux program session I get the delay before opening. So I was wondering if that is normal and if others are experiencing the same thing.
Also I've noticed that the temp probe connection doesn't fit completely tight and if you by mistake move its cable a bit harder it loses the connection for a second and then it takes 3-4 secs until it shows again the right temperature. It doesn't completely loses the temperature but just change the numbers for a short period of time. So ya I am just concerned if thats normal because the controller is brand new, purchased it as megapack.
I'm running ProfiLuxControl 5.1.1.2 and FW 5.11
So anyone else noticed this lag in the PLC?
Hello,
I recently purchased P3 eX, connected it via usb and now using the pc software. The thing is that when I click on a section (e.g. sensors) and then click on another section I get 2-3 sec lag until it opens it. After that I get no lag but if I do it for the first time in the current profilux program session I get the delay before opening. So I was wondering if that is normal and if others are experiencing the same thing.
Also I've noticed that the temp probe connection doesn't fit completely tight and if you by mistake move its cable a bit harder it loses the connection for a second and then it takes 3-4 secs until it shows again the right temperature. It doesn't completely loses the temperature but just change the numbers for a short period of time. So ya I am just concerned if thats normal because the controller is brand new, purchased it as megapack.
I'm running ProfiLuxControl 5.1.1.2 and FW 5.11
So anyone else noticed this lag in the PLC?