PDA

View Full Version : ProfiluxII update from 4.06 to5.1



arkoujohn
15.09.2011, 06:29
Hello!
I tried to update firmware 4.06 to 5.1, but I got a message "Error while transmiting firmware"
I have a similar problem when trying to store my settings I did the following:
file---> Transmit all settings from profilux to file
and I got a message "Cannot open parameter definition file ParaList_V4.06_ProfiluxPlusII.def"

I want to update firmware because a purchased two AI sol blue units that I would like to connect to my profilux computer.

Anyone?

GHL Support
15.09.2011, 06:56
General things to check:
you use the original black ProfiLux serial cable (PL-ser)
or you use an USB to serial Adapter in series with the original black ProfiLux serial cable (PL-ser)
you followed the instructions at the PLC screen step for step (especially the message "Please confirm the message at the device with <Yes> ...." - you have to select "Yes" at the ProfiLux before you click to "Ok" at PLC)

arkoujohn
15.09.2011, 09:15
yes that was the problem I selected yes on the device and the update began.
I could not back up in the file though.
I am using a usb adapter in series with the original black ProfiLux serial cable
After the update and the device rebooted I get a meesege on the device "einstellungen rueckgesetzt"
Is that O.K.?

GHL Support
15.09.2011, 11:39
Yes this is ok.

The new firmware has several changes and new settings - therefore the ProfiLux starts with default parameters.