Blahenazo
28.08.2011, 09:15
Hello,
yesterday I was working on my tank (water change) , reorganized my calcreactor etc.... and I emptied my tank to far and could make new water. so I left the ATO alarm active so I could in the next couple of days use my ATO to fill the tank to the correct level. (it was a tad too salty anyway )
luckily , This morning I continued my work , and I noticed that my fans stop / started / stop /started , the powerbar was switching very othen on the chiller socket, => temp changes this fast on a 800 liter tank ???
anyway I connected plc and I noticed the temp probe was tell it red 38 °c , then nothing, 38 °C etc....
and yes the temp probe cable had inched out a few mm.
In the end all was well, but I would like to have had an alarm , I didn't get one since the level alarm was still triggered. :(
and if you imagine all big setups will multiple ex boxes steering multiple tanks , its just not very reassuring there is only 1 alarm.
yesterday I was working on my tank (water change) , reorganized my calcreactor etc.... and I emptied my tank to far and could make new water. so I left the ATO alarm active so I could in the next couple of days use my ATO to fill the tank to the correct level. (it was a tad too salty anyway )
luckily , This morning I continued my work , and I noticed that my fans stop / started / stop /started , the powerbar was switching very othen on the chiller socket, => temp changes this fast on a 800 liter tank ???
anyway I connected plc and I noticed the temp probe was tell it red 38 °c , then nothing, 38 °C etc....
and yes the temp probe cable had inched out a few mm.
In the end all was well, but I would like to have had an alarm , I didn't get one since the level alarm was still triggered. :(
and if you imagine all big setups will multiple ex boxes steering multiple tanks , its just not very reassuring there is only 1 alarm.