Vortech during maintenance - in Profilux controlled mode.

[heliart]

I want to double check the function of the Vortech controller when in maintenance mode. I'm running my Vortechs in Profilux controlled mode.

I want to turn off the Vortech pumps and the return pump during maintenance.
But, I find if I switch the power off to the Vortech pumps, when you come out of maintenance, the pumps stay at their fallback speed, and they don't seem to come back online under the Profilux control.

Is it valid to power them down (via switching the AC), or is there a way to run functionally turn them off, as in feed mode?

Cheers,

Steve

[Matthias]

I am not sure if it is is valid just to switch of the supply power - this question can only be answered by EcoTech.

We are going to extend the firmware of our VorTech-Controller very soon, then you can define settings for maintenance, feed pause and thunderstorm.

[heliart]

OK, great. Having this in the firmware would be really helpful.

Cheers,

Steve

[Matthias]

The new Vortech-Controller firmware 1.03 supports special settings during maintenance. See new manual. Available now.