PDA

View Full Version : Profilux Touch PLC control software



Himat
03.06.2011, 19:06
Is there a plc software for the touch, I have the latest firmware Software but cannot find this control.

The Profilux Touch manual makes reference to this.

TheManicFishkeeper
03.06.2011, 20:03
Profilux needs to be Running Firmware Version 5.08 or higher to support the Touch, and the software also needs to be 5.08 or above.

You may need to assign your Touch as a PAB device before you can access it in the software.

Himat
04.06.2011, 09:42
how do i assign the touch, i have firmware/software 5.09

Blahenazo
04.06.2011, 17:36
admistering PAB devices happens on the P3 in the PAB menu . Check the PAB manual in the download section.

Himat
05.06.2011, 11:36
I have checked the PAB manual, I have the touch working and displaying, I would like to change the setting using the PLC programme.

i need a step by step idiot guide as I don't see the touch option in the PLC programme.

Coralleida
05.06.2011, 21:09
Under System Menu -> PAB -> Assign Devices
Make sure you check the litlle box where it says PTxxxxxx (where xxx is you ProfiLux Touch's serial number)

After that, execute ProfiLuxcontrol and you'll see a new item in your menu on the right

Himat
05.06.2011, 22:51
thank you Coralleida

followed your instruction, sorted out now I see the extra menu.

thanks

M007
08.10.2012, 15:36
One additional bit, you can only carry out this action directly at the P3 and not via the PC software.