View Full Version : P3 - Ex upgrade issues with Cond
turaki tim
14.05.2011, 18:26
Hi team!
I just upgraded my P3 to eX.
After the upgrade I also uploaded FW 5.07
However, type is still Profilux 3 and the Cond probe reads 0mS.
Any thoughts please?
TheManicFishkeeper
14.05.2011, 22:25
Did you run the command "hardware-upgrade eXtended" from the "Extra's" menu in the Profilux Control Software.
turaki tim
15.05.2011, 16:53
I found the command and all is working now.
HOWEVER - the Cond reading on the P3 is equivalent to a salinity (PTU) of 26, or less than 30mS!!! On my dd20 ATC refractometer, it reads 34ppt. One is obviously very wrong and I must admit that I have been struggling with STN on a lot of my SPS recently. Have I been trying to keep my reef at a very low salinity recently, which would explain de deterioration?
Any thoughts?
TheManicFishkeeper
15.05.2011, 19:20
Try recalibrating the Probe, but make sure you float your Calibration fluids in your tank/sump for a while so the temperatures match, seemed to help me get a more accurate reading
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.