View Full Version : dcf module
Hi I placed (my working) dcf module from my profilux 2 to the profilux 3, but it doesn't find the radio time like before. With the p2 a antenna was blinking onces in a while now with the p3 i don't see that happening, is it a different module?
Many thx,
Eugene
Matthias
03.04.2011, 09:00
no, it is the same
please swap the power supplies of PII and P3 for a test
Hi Matthias,
I did swap the supplies but it stays the same! they told me I could use all my old stuff (PLM-2L4S 2x and the eX kit) but untill now dcf is not workong condutivity is not working!
I don't know now if my saltinity is oke now.
plz help me
thx
Hello,
sure the DCF works also on the PL3.
I used it in the Pl2 and now on then.
I don't need to do anything else than put it in the dcf box and Switch the dcf mode in PLC on.
Mathias the time on my p3 is running very slow this morgen i set the pc time (8u) and now (11:45) it running 15 minutes late!
is there someting I can do now? is it possible tot exchange the module at Zajac? do you know a sollution for the condutivity? many thx!
Eugene
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.