dcf module

[scrub29]

Hi I placed (my working) dcf module from my profilux 2 to the profilux 3, but it doesn't find the radio time like before. With the p2 a antenna was blinking onces in a while now with the p3 i don't see that happening, is it a different module?

Many thx,

Eugene

[Matthias]

no, it is the same

please swap the power supplies of PII and P3 for a test

[scrub29]

Hi Matthias,

I did swap the supplies but it stays the same! they told me I could use all my old stuff (PLM-2L4S 2x and the eX kit) but untill now dcf is not workong condutivity is not working!
I don't know now if my saltinity is oke now.
plz help me

thx

[Lalune]

Hello,

sure the DCF works also on the PL3.

I used it in the Pl2 and now on then.

I don't need to do anything else than put it in the dcf box and Switch the dcf mode in PLC on.

[scrub29]

Mathias the time on my p3 is running very slow this morgen i set the pc time (8u) and now (11:45) it running 15 minutes late!

is there someting I can do now? is it possible tot exchange the module at Zajac? do you know a sollution for the condutivity? many thx!

Eugene