View Full Version : conductivity
hello,
i put in the extend card in my profilux 3 and conect the ghl conductance dontrole sensor, i installed the card and everything is working except the conductivity, its not vissable for me, not on the profilux not on the software.
what can i do!
MANY THX
Matthias
31.03.2011, 16:48
are we talking about an expansion card (PLM-XXX) or about the eX-Upgrade Kit?
are we talking about an expansion card (PLM-XXX) or about the eX-Upgrade Kit? the ex-upgrade kit, everything else is working from the kit
thx mathias
Matthias
01.04.2011, 07:05
did you perform the update with ProfiLuxControl as mentioned in the manual?
is your ProfiLux recognized as ProfiLux eX when connecting with PLC?
Hi Mathias,
yes I did, I don't know if it recognized the module but the lightning that I connected is working. The module came out my old profilux 2. Manfred Zajac (zajac duisburg) told my switching the kit is no problem. on the profilux 2 it did work!
many thx Eugene
Matthias
01.04.2011, 10:01
is your ProfiLux recognized as ProfiLux eX when connecting with PLC?
I'm sorry Mathias but how can I find out if it is?
Matthias
01.04.2011, 13:14
you see this at the first page after connecting
next to "type"
above the control panel?
ghl profilux 3 eX, is this what you mean?
Hello,
anyone got an idea? I dont know what to do!!
many thx
GHL Support
06.04.2011, 09:26
The only idea we have is to do a firmware update and to get back to the factory settings. Don't reload stored settings. This could help.
Hi Carolin I did do an update when I bought it last week I installed the eX kit and did an update.
Where can I complain? in the shop where I bougt the Profilux 3?
Please help me out!
many thx
Eugene
The only idea we have is to do a firmware update and to get back to the factory settings. Don't reload stored settings. This could help.
Hi carolin,
i did the upgrade again with no possitieve results , I also still have the problem of the dcf that was working on my profilux 2 and isn't working on p3. the seller garantied me that the eX kit and dcf module and my both PLM-2L4S cards would work on the p3 but until now only the two PLM-2L4S
cards are working propperly.
GHL Support
07.04.2011, 09:19
Yes, then the best would be to contact your retailer regarding the ProfiLux 3.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.