almost
23.02.2011, 12:07
My return pump is connected to the 6D Powerbar of Ghl.
It is connected there, so as to stop when feeding (otherwise plenty of food goes to the sump through the overflow box).
In lack of power, I would like to connect a UPS, so the return Pump continues working.
The problem:
1. If I connect the inlet of the UPS to the 6D powerbar when press ESC the UPS will give power to the return pump. So, no feeding pause.
2. If I connect the inlet of the UPS to the 220V and all the 6D powerbar to the UPS (the shuco of the 6D), then all 6 jacks of the powerbar will have power after power failure. That means I need an extremely big UPS (& expensive) since the heater only is 500W (the return pump is 85W).
Any idea were/how to connect UPS?
(Profi 3ex, dosing pumps etc would also be on the UPS to protect them from Voltage range)
It is connected there, so as to stop when feeding (otherwise plenty of food goes to the sump through the overflow box).
In lack of power, I would like to connect a UPS, so the return Pump continues working.
The problem:
1. If I connect the inlet of the UPS to the 6D powerbar when press ESC the UPS will give power to the return pump. So, no feeding pause.
2. If I connect the inlet of the UPS to the 220V and all the 6D powerbar to the UPS (the shuco of the 6D), then all 6 jacks of the powerbar will have power after power failure. That means I need an extremely big UPS (& expensive) since the heater only is 500W (the return pump is 85W).
Any idea were/how to connect UPS?
(Profi 3ex, dosing pumps etc would also be on the UPS to protect them from Voltage range)