PDA

View Full Version : Maintenance



CEDRIC78
22.02.2011, 22:24
Hello when I stop maintenance, I want the level sensors is disabled for a few minutes. but I can not figure out how to make this work.:confused:
cordially cedric

Blahenazo
22.02.2011, 23:01
wel levels are currently not in the maintenance step of this controller , maybe you can do a feature request

but maybe you can play a little with the reaction time of the level sensors and put it longer then the time you need to get a stable system after maintenance.
(this offcourse depends if you can have this delay on your level sensor in 'normal' behaviour.)

CEDRIC78
28.02.2011, 22:36
Hello,
I am writing to give you the solution I found.
osmoles my system will consist of two sensors.
No. 1 for the outbreak of the fresh water pump.
No. 2 for the detection of water level too high in the settling stops the fresh water pump and the skimmer to prevent it from racing.
when I made the maintenence all the pumps are off.
when I sort of maintenence I request a timeout on the skimmer and pump fresh water.
I do like that and it's working perfectly.
Here are two pictures to show you that it is possible.
http://imagik.fr/uploads/376216
http://imagik.fr/uploads/376213

Antipodes
01.03.2011, 07:47
Thanks Cedric78 good work on progressing that and making it work.
Would like to see a wiki or something like it, to copy all this good information too.