PDA

Archiv verlassen und diese Seite im Standarddesign anzeigen : Feed Pause delay start of skimmer



plankton
23.01.2011, 06:08
I have a skimmer on Socket 3. Everytime the feed pause ends the skimmer overflows and a bunch of skimmate goes into my sump, not a good thing. Is there a way to set socket 3 to delay start after feed pause ends so that the sump level goes to its normal level before the skimmer starts again?

boboxx
24.01.2011, 11:38
In Programmable Logic G1 =
input : Filter
Time: 480 sec (8 min)
Function: Delay On

Then assign programable Logic 1 to your skimmer socket #3

plankton
24.01.2011, 16:35
Thanks, I will try and "program" it but is seems like a round-about solution for a common problem. You should consider making this be an easy check bok for a socket function. Most other controllers have this function readily available.

plankton
31.05.2011, 22:23
Is it possible to extend the feed pause timer past 10 minutes, I want it to be 20 minutes.

Blahenazo
03.06.2011, 15:50
I believe its already possible to do this ,( at least I had mine @ 14 mins ) but never bothered timing it :)

plankton
03.06.2011, 19:47
the max right now is 10 minutes. I wish i could make it 20

Blahenazo
04.06.2011, 07:20
Well, I've just tested it and I have my FP @ 15 mins and when I press esc on the controller it counts down from 900 to 0 so that's still 15 mins

I'm using FW 5.07 and PLC 5.07

plankton
04.06.2011, 15:34
Well, I've just tested it and I have my FP @ 15 mins and when I press esc on the controller it counts down from 900 to 0 so that's still 15 mins

I'm using FW 5.07 and PLC 5.07


yup I tried it, it works. thanks.