Chinaexpat
03.01.2011, 17:02
I just got my Profilux 3 and Expansion Box.
I constantly get communication errors and have to disconnect my USB cable in order to close the Profilux software, and tehn restart it, is this normal?
What I am trying to do is to have 2 pumps alternate, creating a pulsing motion. I had this with my Tunze 7095 Controller but want to use the Profilux to control them instead.
I have L13L14 connected to a Y-slitter (on my expansion box) and from the Y-Splitter one cable going to Tunze pump #1 and the other cable out of the splitter going to Tunze pump #2.
The display only shows Pu.1 0% nothing for pump 2 although and one pump is running!
I am only using Group 1 and have both pumps set up in Group 1.
setting "Permanent Opposite"
Pause Duration 2 minutes.
Count of pumps in Group 1 = 2
No waves
Any help is appreciated!
I constantly get communication errors and have to disconnect my USB cable in order to close the Profilux software, and tehn restart it, is this normal?
What I am trying to do is to have 2 pumps alternate, creating a pulsing motion. I had this with my Tunze 7095 Controller but want to use the Profilux to control them instead.
I have L13L14 connected to a Y-slitter (on my expansion box) and from the Y-Splitter one cable going to Tunze pump #1 and the other cable out of the splitter going to Tunze pump #2.
The display only shows Pu.1 0% nothing for pump 2 although and one pump is running!
I am only using Group 1 and have both pumps set up in Group 1.
setting "Permanent Opposite"
Pause Duration 2 minutes.
Count of pumps in Group 1 = 2
No waves
Any help is appreciated!