PDA

View Full Version : DE Lightings T5 Unit control



locuus
08.12.2010, 13:23
Hi
I have 2x T5 DE Lighting units I am looking to control with my Profilux 3. The units are wired to plugs and I am unsure what module I would need for control.
Thanks in advance

GHL Support
08.12.2010, 14:44
Hello,
are these lamps simply T5-tubes?
Then you have the following options:
-switch them on/off via our powerbars
-dim them by using an adapter like our LBF-AP. Of course you will need at first dimmable ballasts.
Then you can connect them to LBF-AP, it provides two channels but is without internal shut-off.
The board comes along with a control cable that is plugged into a 1-10V-interface at the ProfiLux.
To achieve the shut-off, you must put the power plugs into a Powerbar.
In case the lamps have to be opened, e.g. to build in dimmable ballasts, then you can also use the board EVG-AP-2F
(this has also two channels and internal shut-off, but has no housing, so it has to be installed inside the lamp)

locuus
08.12.2010, 17:54
Thanks for the reply and details.

Yes they are simply T5 Units, ie non dimmable. A powerbar will do the job. Thanks for the reply.