PDA

View Full Version : 4 level sensors



deepblue
10.05.2009, 19:57
Is it possible to controll 4 level sensors with profilux II ex ?

GHL Support
10.05.2009, 20:00
No, only 3.

deepblue
10.05.2009, 20:45
i want to use 3 sensors to control my ro-di with 2 magnetic valves.
When the lowest sensor is on,it should open the 1st valve and start to fill ato tank untill is full (middle sensor).The 3rd sensor is for safety purpose and when is on,it should activate the 2nd valve and shut it in case that the 1st valve get malfuncioned-jammed.The second valve stays open untill it gets electricity.

How to program this?
PS.Now I am missing the 4th sensor for my sump level ,have you any suggestions?

Luisagos
11.05.2009, 00:39
i want to use 3 sensors to control my ro-di with 2 magnetic valves.
When the lowest sensor is on,it should open the 1st valve and start to fill ato tank untill is full (middle sensor).The 3rd sensor is for safety purpose and when is on,it should activate the 2nd valve and shut it in case that the 1st valve get malfuncioned-jammed.The second valve stays open untill it gets electricity.

How to program this?
PS.Now I am missing the 4th sensor for my sump level ,have you any suggestions?


Remove sensor 2 and put a timer on sensor one. You need to calculate how long would it take to reach to sensor 2 level. You still have sensor 3 for back up.
That should clear one of the sensor up for something else, till we get Profilux III.

deepblue
14.05.2009, 20:34
can you help me to program this :confused:

deepblue
16.05.2009, 18:06
can you explain how to programm when level 1 is low to turn on s6 on powerbar and to svitch s6 off after 4 hr and to stays off until is level 1 low again

deepblue
16.05.2009, 18:25
Nwm i figure it out