Firmware Powerbar 6D PAB 1.04

[Coralleida]

What's new in this firmware :confused::confused::confused::confused::confused: :confused:

[Wirus]

http://forum.aquariumcomputer.com/showthread.php?3002-Updating-firmware-of-VorTech-pumps/page3 post #22 says it:


the new firmware supports current measurement

But elsewhere it´s written that it´s supported starting with firmware 5.05 (which is still not available)
Maybe that´s the reason why there´s no announcement yet.

[boboxx]

5.05 is out :)

http://support.aquariumcomputer.com/english/section.php?sid=7

[Coralleida]

Yes, that's right. Thanks to all ;-)

[twister]

I upgraded to FW 1.04 and there was a message "successful". Afterwards the PAB restarted. But in ProfiluxControl it still says "PAB version 1.02". Any idea what might be wrong???

[Stephan]

I had the same behaviour.

After restarting the complete system it was 1.04. Whatever the reason is...


Stephan

[twister]

Thanks! I will try that later on - the animals are already confused cause the sun disappeared very very fast ;-)

[boboxx]

yes I have to power cycle and reassign the pad device to the group