View Full Version : Firmware Powerbar 6D PAB 1.04
Coralleida
26.11.2010, 21:35
What's new in this firmware :confused::confused::confused::confused::confused: :confused:
http://forum.aquariumcomputer.com/showthread.php?3002-Updating-firmware-of-VorTech-pumps/page3 post #22 says it:
the new firmware supports current measurement
But elsewhere it´s written that it´s supported starting with firmware 5.05 (which is still not available)
Maybe that´s the reason why there´s no announcement yet.
5.05 is out :)
http://support.aquariumcomputer.com/english/section.php?sid=7
Coralleida
27.11.2010, 00:52
Yes, that's right. Thanks to all ;-)
I upgraded to FW 1.04 and there was a message "successful". Afterwards the PAB restarted. But in ProfiluxControl it still says "PAB version 1.02". Any idea what might be wrong???
I had the same behaviour.
After restarting the complete system it was 1.04. Whatever the reason is...
Stephan
Thanks! I will try that later on - the animals are already confused cause the sun disappeared very very fast ;-)
yes I have to power cycle and reassign the pad device to the group
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.