View Full Version : ATO Delay
Hello! Would like to know if there's a way to add a delay to ATO detection after maintenance mode is re-enabled? I have my skimmer on Programmable Logic 1 which tells it to delay 60 seconds before turning back on after maintenance is re-enabled. Any chance I can do the same for ATO sensor detection?
Thanks in advance for any assistance!
Matthias
09.11.2010, 16:12
maybe you create a new AND-gate with inputs prog logic1 and water x ?
Okay, I'll give that a try. Thanks!
Let us know how that works and/or what else you do to make it work.
Allen
Not much luck yet. I created a new AND-gate with programmable logic 1 and water 1, but when applied to ATO pump socket, the pump just sit there even when water level is below ATO sensor.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.