deepseanige
25.10.2010, 16:56
Hey,
I have a 6 socket power bar connected to S1-S4 which works fine and I'm now trying to get the dosing pumps running.
From what I can see is I should connect the comms cable to S5-S6, disconnect the power bar comms cable. Then program the "Numbering of a dosing pump station" to, say, 10, 11, 12, 13 and finally reconnect the powerbar comms cable.
I'd then just need to allocate timers to each socket number (10-13) to program what I need to dose.
My problem is, the second I connect the comms cable to the dosing pump all pumps activate on. I then try to reconfigure the numbering on the dosing pumps but it doesn't seem to have any affect and they just continue to whir round. At no stage does the yellow comms light come on?
Any ideas?
Oh, and I'm using a Profilux II Plus.
Thanks
N
I have a 6 socket power bar connected to S1-S4 which works fine and I'm now trying to get the dosing pumps running.
From what I can see is I should connect the comms cable to S5-S6, disconnect the power bar comms cable. Then program the "Numbering of a dosing pump station" to, say, 10, 11, 12, 13 and finally reconnect the powerbar comms cable.
I'd then just need to allocate timers to each socket number (10-13) to program what I need to dose.
My problem is, the second I connect the comms cable to the dosing pump all pumps activate on. I then try to reconfigure the numbering on the dosing pumps but it doesn't seem to have any affect and they just continue to whir round. At no stage does the yellow comms light come on?
Any ideas?
Oh, and I'm using a Profilux II Plus.
Thanks
N