MAXreefer
24.04.2009, 15:17
Before I do something wrong maybe you could help me or give me some suggestions for my ATO.
I have:
Profilux II Ex
GHL Float Switch level Sensor
GHL optical Level Sensor
Aqualifter for pumping the fresh water
I DON'T have the splitter cable but I guess I can connect one sensor to port1 and the other sensor to Port3 ??
What I would like to do:
The mechanical float sensor should turn ON the aqualifter pump when the water level in the sump is to low and turn OFF the pump when the desired level is achieved again.
The optical Level sensor would be my safety net. I would place this one a little higher as the mechanical one and if for some reason the mechanical one fails and the water reaches the level the optical one is monitoring the aqualifter pump need to be shut OFF
My questions:
I plug the Aqualifter pump in a socket on the digital powerbar?
What settings do I use to achieve the scenario I described above?
Thanks for any input
Michael
I have:
Profilux II Ex
GHL Float Switch level Sensor
GHL optical Level Sensor
Aqualifter for pumping the fresh water
I DON'T have the splitter cable but I guess I can connect one sensor to port1 and the other sensor to Port3 ??
What I would like to do:
The mechanical float sensor should turn ON the aqualifter pump when the water level in the sump is to low and turn OFF the pump when the desired level is achieved again.
The optical Level sensor would be my safety net. I would place this one a little higher as the mechanical one and if for some reason the mechanical one fails and the water reaches the level the optical one is monitoring the aqualifter pump need to be shut OFF
My questions:
I plug the Aqualifter pump in a socket on the digital powerbar?
What settings do I use to achieve the scenario I described above?
Thanks for any input
Michael