View Full Version : Screenshoots for Tunze pumps set
I have 2 Tunze Stream 6105 one on the left and one on the right of the tank and I'd like them to work separately for 2 minutes starting from minimum power arriving maximum power.Could you please send me screenshoots for this setting?Thank you.
Matthias
08.07.2010, 16:47
for example like this:
576
of course these settings have to be finetuned for your needs
Matthias
08.07.2010, 16:48
don't forget to set the function of the 2 1-10V-interfaces (e.g. L1 and L2 or L3 and L4) to "current pump 1" and "current pump 2"
and to set the min voltage to 3v and max to 8v
for example like this:
576
of course these settings have to be finetuned for your needs
Thank you Matthias
and to set the min voltage to 3v and max to 8v
Thank you for your advice Boboxx could you please let me know where I must set this data?
don't forget to set the function of the 2 1-10V-interfaces (e.g. L1 and L2 or L3 and L4) to "current pump 1" and "current pump 2"
Since I have all the L port empty behind the Profilux 3ex and since I dont like to have too many cable around may I connect one pump in one L port and the other one in the other L port without using the Y adapter?
Blahenazo
11.07.2010, 14:14
offcourse you can.
I've been doing that since I got my p3 ex
the voltage is set in PLC in System > 1-10V Iterface
For some reason my 2 pumps wouldnt work on Sequence 1 or 2. they only work on permanet or perm opposite mode. what could be possably wrong?
when i set on Sequence 1 i can see state is counting % but, pumps are dead.
offcourse you can.
I've been doing that since I got my p3 ex
Thank you!
the voltage is set in PLC in System > 1-10V Iterface
Thank you I'll try.
Is working now thank you everybody!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.