PDA

View Full Version : Lan question / problem


90reefernyc
10.05.2010, 00:55
I recently had my linksys router zap out on me that I had my profilux 3 hard wired to with an Ethernet cable. I didnt buy a new router but instead connected it to the Verizon Fios router that was installed when I got fios. I set it up the same way I had it before it worked for a couple of days and then it cant connect?
I reconfigured the setting again set up new IP for profilux it worked for a day and then it cant connect again?
Also I noticed that when my computer is connected with the Ethernet cable to the same router that the profilux is connected too I cant connect to the profilux no matter what I do?
I know it has to do with my router but cant figure it out. If there is someone on here that can help I would appreciate it...
Thank you, Jimmy
Matthias
10.05.2010, 08:10
I think the problem is that your computer uses 2 network adaptors at the same time, ProfiLuxControl choses the wrong one and can't disconnect

maybe you can adjust which of both is the primary adaptor
90reefernyc
11.05.2010, 04:36
I think the problem is that your computer uses 2 network adaptors at the same time, ProfiLuxControl choses the wrong one and can't disconnect

maybe you can adjust which of both is the primary adaptor

I will need some help in figuring this out I am computer illiterate LOL
Also today it was connecting while I was on my laptop wireless through my router but the profilux control kept dropping out like every 2 minutes? This is also something new that is happening all of a sudden:confused:
Matthias
18.05.2010, 09:19
are you using the newest ProfiLuxControl and firmware?

they were optimized to keep the connections stable even under bad connection conditions
90reefernyc
19.05.2010, 04:57
Whats the newest non-beta version for the p3?
Havent been on the forum in a while.
Thanks Jimmy
GHL Support
19.05.2010, 07:22
The latest non beta for ProfiLux3 is version 5.00q.