freemchr
08.05.2010, 09:02
Hi All,
Received some new probes and all is well. Calibrated the Redox probe and shows up fine on the calibration fluid at 220mv.
However when in the tank the redox jumps up and down from -15 to 20 to 80 and then back down and up again.
Putting the probe back in the redox fluid it reads 220mv perfectly. Could it be that it is in a fairly high flow area? or that it just takes some time to adjust?
ADC1 is 473
ADC2 is 581
Thanks again
Received some new probes and all is well. Calibrated the Redox probe and shows up fine on the calibration fluid at 220mv.
However when in the tank the redox jumps up and down from -15 to 20 to 80 and then back down and up again.
Putting the probe back in the redox fluid it reads 220mv perfectly. Could it be that it is in a fairly high flow area? or that it just takes some time to adjust?
ADC1 is 473
ADC2 is 581
Thanks again