View Full Version : Dali module and OSRAM quicktronic
aquatixguru
12.04.2010, 20:13
Hello, everyone.
I am new to profilux and I am trying to connect the
Dali interface to the osram quicktronic 2x54W ballasts.
As I run the recognise funtion on profilux I do not recognise the lamps.
I have bought 3 ballasts of this type. and discarded the old ones. to keep more free L ports.
Any thoughts? Advice?
Should the ballast be power on to be recognized or off ?
The cable to connect what type? does it matter?
Matthias
13.04.2010, 07:48
the Osram QTi DALI will work with the ProfiLux when the wiring is correct
(no short circuits or open connections)
the ballasts must have power during scanning
cable type - not so important, recommended min. 0.5qmm
aquatixguru
13.04.2010, 13:12
the Osram QTi DALI will work with the ProfiLux when the wiring is correct
(no short circuits or open connections)
the ballasts must have power during scanning
cable type - not so important, recommended min. 0.5qmm
Thank you Matthias,
I will check again connections and give it another try.
aquatixguru
14.04.2010, 22:13
Hello, everyone.
I am new to profilux and I am trying to connect the
Dali interface to the osram quicktronic 2x54W ballasts.
As I run the recognise funtion on profilux I do not recognise the lamps.
I have bought 3 ballasts of this type. and discarded the old ones. to keep more free L ports.
Any thoughts? Advice?
Should the ballast be power on to be recognized or off ?
The cable to connect what type? does it matter?
I tried again.
I connect 1 ballast (tried with each on of the 3)
When I run new numbering on the profilux itself it reads Ready - 0
When I click assign and I choose 1 it turns off the lamp that it is connected to, until I disconect the one of the dalli cables.
any thoughts?
GHL Support
16.04.2010, 07:21
If all other seems correct and any other source for problems could be excluded, there may be a problem with your DALI card.
In this case you should send us the card to check this.
aquatixguru
30.01.2011, 20:26
Update:
I recented ordered a new Dali card , connected it and all works fine.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.