Dali module and OSRAM quicktronic

[aquatixguru]

Hello, everyone.

I am new to profilux and I am trying to connect the
Dali interface to the osram quicktronic 2x54W ballasts.

As I run the recognise funtion on profilux I do not recognise the lamps.
I have bought 3 ballasts of this type. and discarded the old ones. to keep more free L ports.

Any thoughts? Advice?
Should the ballast be power on to be recognized or off ?
The cable to connect what type? does it matter?

[Matthias]

the Osram QTi DALI will work with the ProfiLux when the wiring is correct
(no short circuits or open connections)
the ballasts must have power during scanning

cable type - not so important, recommended min. 0.5qmm

[aquatixguru]

the Osram QTi DALI will work with the ProfiLux when the wiring is correct
(no short circuits or open connections)
the ballasts must have power during scanning

cable type - not so important, recommended min. 0.5qmm

Thank you Matthias,

I will check again connections and give it another try.

[aquatixguru]

Hello, everyone.

I am new to profilux and I am trying to connect the
Dali interface to the osram quicktronic 2x54W ballasts.

As I run the recognise funtion on profilux I do not recognise the lamps.
I have bought 3 ballasts of this type. and discarded the old ones. to keep more free L ports.

Any thoughts? Advice?
Should the ballast be power on to be recognized or off ?
The cable to connect what type? does it matter?




I tried again.
I connect 1 ballast (tried with each on of the 3)
When I run new numbering on the profilux itself it reads Ready - 0
When I click assign and I choose 1 it turns off the lamp that it is connected to, until I disconect the one of the dalli cables.

any thoughts?

[GHL Support]

If all other seems correct and any other source for problems could be excluded, there may be a problem with your DALI card.
In this case you should send us the card to check this.

[aquatixguru]

Update:

I recented ordered a new Dali card , connected it and all works fine.