subshop
04.04.2010, 06:13
OK its been hours now and to surrender! I have had my PII a couple of years now and have been waiting to do the PIII UPGRADE a couple of months. I just waited until now because if lack of time. I installed the PIII kit and it was pretty straight forward. Unit came on and all was good. I installed the ProfiLuxControl, Version 5.0.0.12 (BETA). Then I tried to do a firmware upgrade and my problems began.
Before anyone asks: I have been running Vista in Parallels on a MAC. Hardwire Profilux to Lan and MAC to WLAN to network. This worked fine with the PII and in the beginning with the PIII. I had always done firmware updates without any problems.
When I tried to do the firmware update, I hit Yes on the Profilux then OK on my screen. About 3/4 of the way through the upgrade I got an Error message saying "ERROR WHILE TRANSMITTING FIRMWARE Flasherase - no response - 255.
Then I tried to save the setting to my PC and got this message "Error during reception of Code_WebServer Port (Parameter #1830)". After Retrying a number of times I hit Ignore to see what would happen.The next message I got said "Error during reception of Code_level1_props_1-0(Parameter #1927). If I continue to hit ignore the message was with (Parameter #1927), Ignore again then (Parameter #1928), Ignore again then (Parameter #1929). I stopped when it reached (Parameter #1930)
Now even if I could not the fireware upgrade or be able to store the settings would have been OK for now but I noticed that on the Profilux display not all viewable items are shown even though they are checked on the Profilux control.
Any and all help is appreciated, Neil.
Before anyone asks: I have been running Vista in Parallels on a MAC. Hardwire Profilux to Lan and MAC to WLAN to network. This worked fine with the PII and in the beginning with the PIII. I had always done firmware updates without any problems.
When I tried to do the firmware update, I hit Yes on the Profilux then OK on my screen. About 3/4 of the way through the upgrade I got an Error message saying "ERROR WHILE TRANSMITTING FIRMWARE Flasherase - no response - 255.
Then I tried to save the setting to my PC and got this message "Error during reception of Code_WebServer Port (Parameter #1830)". After Retrying a number of times I hit Ignore to see what would happen.The next message I got said "Error during reception of Code_level1_props_1-0(Parameter #1927). If I continue to hit ignore the message was with (Parameter #1927), Ignore again then (Parameter #1928), Ignore again then (Parameter #1929). I stopped when it reached (Parameter #1930)
Now even if I could not the fireware upgrade or be able to store the settings would have been OK for now but I noticed that on the Profilux display not all viewable items are shown even though they are checked on the Profilux control.
Any and all help is appreciated, Neil.