View Full Version : Help After Firmware Update
Hi, I just updated the firmware of my PlusII EX from 4.05 to 5.00 but now the ProfiLux settings are in German :eek: and I don't know how to reactivate controls so that I can connect to my PC to upload my settings. Can anyone tell me what words in German I should be looking for on my ProfiLux to reactivate the controls or switch the language back to English.
Thanks in advance... David :)
OK I've managed to get the Profilux back to English but since I upgraded the firmware to it won't connect to my computer, I am using ProfiluxControl II version 4.0.8.1 Is it OK for me to install ProfiluxControl version 5.0.0.11 to use with Profilux II
David.
Matthias
26.03.2010, 08:32
with firmware 5.xx you must use ProfiLuxControl 5.0.0.11 !
important: never load back the old settings or sensordata from firmware 4.xx to the ProfiLux with 5.xx firmware - they are not compatible!
OK Matthias thanks for that, does that mean I will have to recalibrate everything? I have never used my Profilux yet BTW and I'm just getting ready to upgrade it to a PIII, I already have the kit.
David.
Matthias
26.03.2010, 11:10
yes, all probes have to be calibrated (not the temp.-probe)
Would I have had to do that anyway even if I hadn't updated the firmware, and will I have to do it again when I update the PII to the PIII?
David.
Matthias
26.03.2010, 19:23
Would I have had to do that anyway even if I hadn't updated the firmware?
yes
and will I have to do it again when I update the PII to the PIII?
no, because you have 5.00 before and after the update -> you can save the sensor data in this case
When I upgrade my PII to PIII will I be able to connect it my PC using USB?
David.
Blahenazo
27.03.2010, 20:34
P3 supports USB out of the box,
I don't see why not.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.