Wlan

[Tmat]

Hi there,

I have a problem setting a Ip adr on the profilux.

If i connect through profiluxcontrol I can see the wlan card, and then i change the IP and ssid... when I press save, the display on the profilux is displaying "reset module" the same thing happens if i change the ip directly on the profilux.. but no changes has been made on it :mad:

Someone have a good answer?

[GHL Support]

You never get an Information on witch IP or SSID the W-Lan module is right now on Profilux oder Control. It is only a one way communication possible at this point. If you set an special IP and SSID and the module is resetting the Modul has the special IP and SSID.

[kidney514]

Take a look at this
http://www.aquariumcomputer.com/Forum/showthread.php?p=713#post713

Alos one question, are you running "Mixed mode BNG" on your router?