View Full Version : Please help cooling setting!!!!!!!1
Hi, I'm new with profilux controller .
Anybody can help tell me how to set the cooler on & off ?
Current temp 25++ , I want to on the cooler at 26c and to off at 25c.
I' m not using heater. Just 1hp compressor. Is using socket 4 .
Matthias
24.03.2010, 08:07
set the desired temp. as needed (maybe you also change the hysteresis and cooling difference)
then assign the function "temp. 1 cooling" to the socket in question
everything covered in the programmer's guide
Can u show me how is it? don't understand what the manual is talking.
hysteresis ????
cooling difference ????
I just want if over 26c drop to 25c.
already waste 2 day to setting this :mad::confused::(
Matthias
24.03.2010, 17:49
set the temp. to 25°C and the hyseresis to 1°C, that's it
last step set the socketfunction to temp 1 cooler
I really don't know where the problem is
Hi Matthias,
Ur mean is set the nominal to 25c ?
hyseresis to 1°C then the cooling difference to 0?
This step I try so many time already...
Why Temp drop to 23c ,the socket still on ?????:confused::confused::confused:
Matthias
25.03.2010, 18:54
please post screenshots of the temp. - and socket-settings
Hi Matthias,
I get it, problem is from socket setting .
so thank you very much.:D:p
Ken Good
03.04.2010, 15:34
If you set nominal to 25 and hysteresis to 1, isn't the result that the cooler comes on at 25.5 and goes off at 25. If you want it to come on at 26 and go off at 25, would the hysteresis have to be changed to 2? Just asking.
Ken
Matthias
04.04.2010, 11:36
If you set nominal to 25 and hysteresis to 1, isn't the result that the cooler comes on at 25.5 and goes off at 25. If you want it to come on at 26 and go off at 25, would the hysteresis have to be changed to 2? Just asking.
Ken
Ken, you are right - because the hyseresis covers the complete invervall from switching a heater (too cold) to switching a chiller (too warm)
if someone wants to know these things in detail: read more about sensor settings in the manual ...
Ken, you are right - because the hyseresis covers the complete invervall from switching a heater (too cold) to switching a chiller (too warm)
if someone wants to know these things in detail: read more about sensor settings in the manual ...
Thank you , Matthias and Ken good ,I get it.:p:p:p
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.