NiXoN
27.03.2009, 10:11
So first time writing in this forum, but probably not the last;)
I am planning to run 2x400w metal halides on a 1meter long tank to avoid single light source shading of the corals.
But in order to avoid heat I would like to run the lamps one at the time whit 2-3 minutes of crossover.
-Will there be any problems whit the load on the digital powerbar?
-I have heard that I should only use the 4 outer sockets of the 6 on my powerbar for such high loads, is this true?
Parts involved…
ProfiluxPlus 2 ex
6Chanel digital powerbar.
//NiXoN
I am planning to run 2x400w metal halides on a 1meter long tank to avoid single light source shading of the corals.
But in order to avoid heat I would like to run the lamps one at the time whit 2-3 minutes of crossover.
-Will there be any problems whit the load on the digital powerbar?
-I have heard that I should only use the 4 outer sockets of the 6 on my powerbar for such high loads, is this true?
Parts involved…
ProfiluxPlus 2 ex
6Chanel digital powerbar.
//NiXoN