Martien
15.03.2010, 19:12
Hi,
I also need some help with the programming of the profilux II
I need to find out if it is possible before buying the sensors and switch blocks.
I have an 60 ltr Osmose tank in wich I want place 2 sensors ( Sensor 1 and 2 )
Into the bottem of the osmose tank the water is flowing to my aquarium. If the tank is full it takes 3 to 4 days when it is empty again.
Sensor1 is the upper sensor and says the tank is full.
Sensor2 is placed where the tank is about 70% filled.
S5 is handling the magnetic switch for the Osmose water ( KO )
S6 is handling the magnetic switch for the Drink Water ( KW )
S7 is an air pump wich will mix the Osmose and Drink Water.
Let start with an empty tank.
Sensor1=0 , Sensor2=0 , S5=1, S6=0, S7=0
Tank starts to fill with Osmose Water.
Then the water reach Sensor 2.
Sensor1=0, Sensor2=1, then S5=1, S6=1, S7=1
Tank is stiil filled with Osmose Water but also filled with Drink Water.
Then the tank is full
Sensor1=1, Sensor2=1, then S5=0, S6=0, S7=1
Then if the water lowers sensor 2
Sensor1=0, Sensor2=0, S5=0, S6=0 then S7=0 after x hours
Shut off air pump after x hours
Then the sequence starts again after 3-4 days.
Is it possible to do with the ProfiluxII ?
How to do ?
I think this will be an exam question ;-)
Kind regards,
Martien
I also need some help with the programming of the profilux II
I need to find out if it is possible before buying the sensors and switch blocks.
I have an 60 ltr Osmose tank in wich I want place 2 sensors ( Sensor 1 and 2 )
Into the bottem of the osmose tank the water is flowing to my aquarium. If the tank is full it takes 3 to 4 days when it is empty again.
Sensor1 is the upper sensor and says the tank is full.
Sensor2 is placed where the tank is about 70% filled.
S5 is handling the magnetic switch for the Osmose water ( KO )
S6 is handling the magnetic switch for the Drink Water ( KW )
S7 is an air pump wich will mix the Osmose and Drink Water.
Let start with an empty tank.
Sensor1=0 , Sensor2=0 , S5=1, S6=0, S7=0
Tank starts to fill with Osmose Water.
Then the water reach Sensor 2.
Sensor1=0, Sensor2=1, then S5=1, S6=1, S7=1
Tank is stiil filled with Osmose Water but also filled with Drink Water.
Then the tank is full
Sensor1=1, Sensor2=1, then S5=0, S6=0, S7=1
Then if the water lowers sensor 2
Sensor1=0, Sensor2=0, S5=0, S6=0 then S7=0 after x hours
Shut off air pump after x hours
Then the sequence starts again after 3-4 days.
Is it possible to do with the ProfiluxII ?
How to do ?
I think this will be an exam question ;-)
Kind regards,
Martien