Aqualab
14.03.2010, 16:05
Need some help here please.
Profilux Plus II - Digital Power Bar - Slave Doser (two pump)
S1-S4 connection. Pump runs in manual mode overide.
I have the dosing pump plugged into socket/outlet #1 on the digital power bar. Socket function S1 is set to timer. I cannot seperate run time on the two pumps - they run in parallel.
I want to dose Parts A&B but with a couple of minutes seperation between the two pump's operation/run time. I have tried several times to program accordingly - no luck. What am I doing wrong?
Should timer #1 switch mode be on Auto Dosing or Normal? If set on Auto Dosing - then I can't control the time of day I want to run dose, only dosing rate? How do you program pump #1 to start at 10:00am and run until 10:01? Pump #2 to start at 10:05am and run until 10:06am? If I set the switch modes to for both pumps to Normal instead, I can control start/stop time, just not doser rate right?
Thanks
Profilux Plus II - Digital Power Bar - Slave Doser (two pump)
S1-S4 connection. Pump runs in manual mode overide.
I have the dosing pump plugged into socket/outlet #1 on the digital power bar. Socket function S1 is set to timer. I cannot seperate run time on the two pumps - they run in parallel.
I want to dose Parts A&B but with a couple of minutes seperation between the two pump's operation/run time. I have tried several times to program accordingly - no luck. What am I doing wrong?
Should timer #1 switch mode be on Auto Dosing or Normal? If set on Auto Dosing - then I can't control the time of day I want to run dose, only dosing rate? How do you program pump #1 to start at 10:00am and run until 10:01? Pump #2 to start at 10:05am and run until 10:06am? If I set the switch modes to for both pumps to Normal instead, I can control start/stop time, just not doser rate right?
Thanks