View Full Version : No temp Reading
Fish Doctors
03.03.2010, 02:34
My Profilux 3 ex has a temp probe attached to the unit.
The front screen reads as follows:
Temp 1 *
when connected to a computer the probe reads accurately. It just doesnot show on the profilux unit.
Matthias
03.03.2010, 11:18
"***" indicates a bad probe or that the probe is not plugged into the correct probe
I think the shown value in ProfiLuxControl is not correct
Fish Doctors
03.03.2010, 22:35
Hello Herr Gross.
There is only one * which is consistent with the cooling function being triggered.
I have tried a spare probe they both seem to act the same (ie probably not probe)
When factory settings is restored the temp 1 reading appears again as :
Temp 1 28.5 * (numerical example) and works normally.
However I loose all my set paramaters.
The problem seems to occur when I try to save my loaded set of parameters and the following error pops up in a box "settings not saved profilux not connected", yet it is.
Specificaly this occurs after Maintenance/Pumps settings are adjusted.
I will try to identify exactly what setting does this.
Matthias
04.03.2010, 08:54
no I understand
firmwareversion?
ProfiLuxControl version?
if not the newest I recommend to update
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.