rossniky
03.03.2010, 01:57
Hi,
Am after a recommended shopping list (and, perhaps some confirmation on whether the below is possible) for a Profilux Plus II unit to look after the following needs:
My intention is to use the 1-10v slots for:
L1 = 1 x Stream
L2 = 1 x Stream
L3 = 1 x Stream
L4 = 1 x Stream
L5 = 3 x Dimmable Meanwell LED Drivers (in parallel) each powering 12 3w White Cree LED's
L6= 2 x Dimmable Meanwell LED Drivers (in parallel) each powering 12 3w White Cree LED's
L7 = 3 x Dimmable Meanwell LED Drivers (in parallel) each powering 12 3w Royal Blue Cree LED's
L8= 2 x Dimmable Meanwell LED Drivers (in parallel) each powering 12 3w Royal Blue Cree LED's
(Note...the meanwells draw 3.3mA so a maximum of 3 in parrallel is as many as I can do I am guessing).
So, other than the Profilux Plus II (now on order...) what cords, splitters and extra expansion slots (I guess) will I require to achieve the above?
I am assuming that I will also require 4 x Light bar - control board (LBF-AP). I think this is the correct component for driving the dimming switches on the meanwells?
In terms of the expansion slots, I would like some room for a dosing pump later down the track.
Look forward to the feedback and the list of parts I will require.
Am after a recommended shopping list (and, perhaps some confirmation on whether the below is possible) for a Profilux Plus II unit to look after the following needs:
My intention is to use the 1-10v slots for:
L1 = 1 x Stream
L2 = 1 x Stream
L3 = 1 x Stream
L4 = 1 x Stream
L5 = 3 x Dimmable Meanwell LED Drivers (in parallel) each powering 12 3w White Cree LED's
L6= 2 x Dimmable Meanwell LED Drivers (in parallel) each powering 12 3w White Cree LED's
L7 = 3 x Dimmable Meanwell LED Drivers (in parallel) each powering 12 3w Royal Blue Cree LED's
L8= 2 x Dimmable Meanwell LED Drivers (in parallel) each powering 12 3w Royal Blue Cree LED's
(Note...the meanwells draw 3.3mA so a maximum of 3 in parrallel is as many as I can do I am guessing).
So, other than the Profilux Plus II (now on order...) what cords, splitters and extra expansion slots (I guess) will I require to achieve the above?
I am assuming that I will also require 4 x Light bar - control board (LBF-AP). I think this is the correct component for driving the dimming switches on the meanwells?
In terms of the expansion slots, I would like some room for a dosing pump later down the track.
Look forward to the feedback and the list of parts I will require.