GHL Control Center v1.1.3.8

[mrtxxx]

Hi,
Few days ago there was available for download GHL Control Center v1.1.3.8. I downloaded but didn’t have time to update on my equipment. I was planing on doing this now but I’ve check the website and this software isn’t available any more.
Can anyone confirm why and maybe if there are any problems that’s why it was taken off from the download page?
Thanks

[Vinny]

GCC 1138 was pulled for revision.

V1137 is currently the most recent public release which can be found here:
https://www.aquariumcomputer.com/downloads/ghl-control-center-v1-1-3-7/

[wega64]

Hello,
I installed GCC1138 and updates the two Profilux 4 (a Doser is connected to each of them and some Mitras Lightbars), which I have.
Should I have any worries ?
The reason for download and upgrading was to test if dynamic steering of temperature based on a file is now working (till now it seems that the downloaded file isn't interpreted correctly) .

Regards

Werner

[Vinny]

Hello Werner,

The revision applied to Doser SA, not ProfiLux controllers.