feed pause current pumps

[Blahenazo]

Hello,


I have a question about an option in profilux control (5.0.0.9) fw 5.00k
I've made a timer that needs to start a feed pause.
Therefore I created a timer => added the period
and used the option ' if active then feed pause'
I didn't do anything else with the timer and my pumps are still attached to there 1-10 v exit , with Current x assigned to them.


When I press feedpause my current pumps are 'off' but the pumps don't seem to do react when the timer is reached.

thx

[Matthias]

Are you sure your timer has been activated?
Check the days for which the timer should be active.

[Blahenazo]

This how I setup the timer

http://users.telenet.be/sjipke/profilux/timer.jpg

[Matthias]

settings are looking good
then there is another option: P3 supports feed pauses for timers 1 -16 at the moment, with new firmware 5.00n (coming this week) all timers can start the feed pause

[Blahenazo]

It's on timer 9.