Ato

[cal_stir]

I run my ato pump on a timer, my evaporation is consistent but my sump level drops as my filter socks plug up so I don't use the ato function, I want to shut the timer socket off if the sump high switch is on.
I can do this with Apex but can't seem to do this with my P4.
Can P4 do this?

[cal_stir]

Figured it out, programmable logic

[otimer]

Yes, you can.
Install a level switch in the sump.
assign this level switch to Leakage Detect.
assign this related Fill Water to the socket outlet where a timer is installed.
Or,
You install the a level switch in your return pump compartment.
And assign this level switch to ATO in level control.
Then assign this ATO function to the socket outlet and connect the ATO feed pump to this outlet w/o timer.
Hope this help.
Son