programming PAB powerbar

[PaxRoma]

I have a PAB powerbar and a conventional 4 sockets power bar. How do I program the profilux 3 so that I can independently control all 10 sockets?

[capri]

1. Plug analog powerbar to S5-S8 of P3.
2. Plug Powerbar PAB and connect the PAB cable.
2. On P3 go to System - Configure PAB - Assign devices - Confirm PAB device.
3. On P3 again go to System - Configure PAB - Set numbering - Start with 9 and confirm. Done

[ilyab]

Hi,

I will jump on this thread :)
What is a difference between connecting powerbar via PAB versus S1-S4 ?
Is there any bennefits using PAB ?

Thanks !

[capri]

PAB powerbars cannot be connected to S1-S4. Communication between PAB devices are through Cat5e cables with RJ45 plugs.

[ilyab]

Thanks, I didn't paid attention that PAB powerbar is different from normal powerbar.