Doser 2.1 - Question on Add-On control and Caluclated Adjustment

[taller51169]

Hello,

Quick question regarding the Calculated Adjustment per dosing value located on the dosing pump overview.

I have noticed that after a sucessfull test with the KHD the Calculated Adjustment per dosing shows a value of "0".
However, the individual dosing times do show an Adjustment rate of "1.0" ml which clearly indicates that an extra ml was added to the dosing schedule in order to compensate for the latest KH test.
Please note, the target value for the KH is 8dKH and the test result was 7.6.

Following the above, shouldnt the Calculated Adjustment value also show 1ml instead of 0? If not, would it be possible for someone to explain when this value is actually changed?

Any clarification here is deeply appreciated. Thanks in advance.

[Thilo]

The adjusted rate shows the normal dosing +- the adjustment. In your case the calculated adjustment is 0.
Please note that the adjustment is first calculated after the first measurement after you've configured the control settings.

[taller51169]

The adjusted rate shows the normal dosing +- the adjustment. In your case the calculated adjustment is 0.
Please note that the adjustment is first calculated after the first measurement after you've configured the control settings.

Hi, thanks for the quick reply.
So just to verify, the adjusted rate shows the amout of ml already added on the dosings while the calculated adjustment shows the amount that was added on the adjusted rate after the latest KHD test?

As an example:

Assuming that the current KH value sits at 7.6 and the current adjustment rate is 1"ml"

Perform a KHD test -> Results in 7.6 -> Calculated Adjustment is "0"ml and adjustment rate is 1"ml"

Perform a KHD test -> Results in 7.0 -> Calculate Adjustment is "1"ml and adjustment rate is now 2"ml"

Is this correct?

Thanks in advance.

[Thilo]

Yes, the 'Calculated adjustment per dosing' shows the calulated adjustment of the control and the 'Adjusted rate' shows the total amount (incl. adjustment) that will be dosed until the next KH measurement.

[taller51169]

Yes, the 'Calculated adjustment per dosing' shows the calulated adjustment of the control and the 'Adjusted rate' shows the total amount (incl. adjustment) that will be dosed until the next KH measurement.

Ok, crystal clear now, thank you so much for the assistance.