68darius13
06.02.2010, 01:02
Hi all,
I purchased an upgrade kit for my Profilux II eX controller. I followed all of the instructions down to the last letter. I swapped all the parts, installed new software and everything looked ok. When the profilux was connected to the computer, I noticed after a while that the software had frozen and the LEDs and screen of the profilux were flashing constantly. Also, the screen displayed the following message:
''Memory test...
All data OK!''
I restarted the software, but it was impossible to establish a link between the profilux and the PC. After a few tries i decided to disassemble the controller to check all the connections, everything looked fine. I hooked everything up again, it was all ok for about 5 minutes (showing readings) then once again the screen and LEDs started blinking and displaying the same message. I've emailed the dealer but I need your advise about what could be going wrong. I suspect that the display (main) panel is faulty.
Any advice would be appreciated.
Thanks
Darius
I purchased an upgrade kit for my Profilux II eX controller. I followed all of the instructions down to the last letter. I swapped all the parts, installed new software and everything looked ok. When the profilux was connected to the computer, I noticed after a while that the software had frozen and the LEDs and screen of the profilux were flashing constantly. Also, the screen displayed the following message:
''Memory test...
All data OK!''
I restarted the software, but it was impossible to establish a link between the profilux and the PC. After a few tries i decided to disassemble the controller to check all the connections, everything looked fine. I hooked everything up again, it was all ok for about 5 minutes (showing readings) then once again the screen and LEDs started blinking and displaying the same message. I've emailed the dealer but I need your advise about what could be going wrong. I suspect that the display (main) panel is faulty.
Any advice would be appreciated.
Thanks
Darius