Assigned PAB devices do not show up?

[smartwater101]

I removed the SA doser and connected it via PAB (from the powerbar) when I assign the device Control center disconnects (as expected) and yet when I reconnect the doser is not there.

https://i.imgur.com/jW5ZmHZ.jpg

https://i.imgur.com/jk4f8qy.jpg

It should be under the powerbar in the hierarchy. I've tried 5+ times but the doser never seems to show up. I even tried several times with the doser plugged directly into the p4 (different cable as well)

thoughts?

[MatthiasF]

Hi,

a Doser2 Standalone can be assigned to the PAB-system after 'downgrading' into Slave mode.
This can be achieved by navigating to the General page in GCC and switching Standalone to Slave mode.
Then assign it in the PAB-setup by selecting the now called 'Doser2 Slave'.