Doser 2

[chrisbascombe1]

Since I’ve had my doser 2 it’s always had the ghl logo blinking red which means alarm
I’ve been told to check the alarm condition of Any pump. And water sensor is met
WHAT DOES THIS MEAN
Then I’ve been told to pab system reset and reasign any devices
The only cable I have is the USB one that came with the doser which was second hand
How do I stop the logo from flashing red


Sent from my iPhone using Tapatalk

[ispookie666]

Is it a standalone or attached to Profilux?

Sent from my SM-N950F using Tapatalk

[chrisbascombe1]

Is it a standalone or attached to Profilux?

Sent from my SM-N950F using Tapatalk

It’s a stand-alone doser 2 sa
Ispookie



Sent from my iPhone using Tapatalk

[ispookie666]

Either way
Check the filling level in dosers from 1-16 (even if you are not using them).

Next look how the dosing pumps are controlled - is it dosing schedule or switch channel ?

PABcom error normally shows up.

Sent from my SM-N950F using Tapatalk

[chrisbascombe1]

Either way
Check the filling level in dosers from 1-16 (even if you are not using them).

Next look how the dosing pumps are controlled - is it dosing schedule or switch channel ?

PABcom error normally shows up.

Sent from my SM-N950F using Tapatalk

All dosing pumps are controlled by dosing shedule


Sent from my iPhone using Tapatalk

[Vinny]

An alarm on a Standalone doser is commonly caused by fluid container levels running low or ATO/AWC function time limit being exceeded.
Solution: Go through each dosing pump channel and click refill container where necessary.

[chrisbascombe1]

An alarm on a Standalone doser is commonly caused by fluid container levels running low or ATO/AWC function time limit being exceeded.
Solution: Go through each dosing pump channel and click refill container where necessary.

Done that still the same
This is getting beyond a joke
All the tech help I’ve received and the problem still exists

Sent from my iPhone using Tapatalk

[Vinny]

We will need more information to better assist you.


Did you connect via the app to see what is causing the alarm?
The app gives you this information.

Did you go through each dosing channel and refill all containers?

Do you have any other dosing units connected to this SA doser?
* If a PAB-cable is disconnected, this will cause the alarm

Do you have any ATO or AWC functions setup?
* If a float or optical sensor becomes lose or detached from the port, an alarm will be activated