Can'nt change assign illumination after an mistake

[milestone]

After installation the DALI card I selected "new numbering"
PL2 found the DALI on number 1. Then I selected "assign illumination" Then I made an mistake by pressing the escape button while Channel <1> was in view instead of <5>. Therefore is now my DALI on ilumination channel 1 (that's where my moonsimulation was on)
I tried several time to change that without success. Can anyone tell how to assign illumination to an other channel?

[Matthias]

this should be no problem, another assignment should fix it

if not - start "new numbering" again

[milestone]

this should be no problem, another assignment should fix it

if not - start "new numbering" again

So I did several time's. It remains on illumination <1>

[GHL Support]

You can change the illumination channel of the DALI if you go to:

System->DALI->Assign Illumin.

Select your DALI (if you have only one, it's number 0). Your DALI now should be on.
Then select your illumination channel (in your case 4).
Then leave with ESC.

That's all.

[milestone]

Thanks, This was really the solution.
I hope that the manual will be rewritten more clearly