PDA

View Full Version : Problem with stirrer



rocco bellafante
18.01.2019, 11:37
Hi alls,
I'm not able to set my new stirrer. I try several ways but it not works.

I have 2 Doso slave. The first one is a 3 head, for ca,kh amg mg. The second one is a four head and i use itfor kh director. In this way i have the last Doso head(7) Free.

I' m not able to set profilux.
I set stirrer 8, with Doso command. 7 Doso ad command.. 1 cicle/day. 1 minut before command and 45 second ad duration...

Any suggestion?
Thanks



Inviato dal mio SM-N950F utilizzando Tapatalk

PIWAWT
18.01.2019, 12:49
Did you choose the right model in the settings of the Stirrer?
11407

regards Pit

rocco bellafante
18.01.2019, 13:59
I haven't this column in my gcc.. have you got master or slave units?https://uploads.tapatalk-cdn.com/20190118/26db471c9847b87b43c92fe6721b4d09.jpg

Inviato dal mio SM-N950F utilizzando Tapatalk

rocco bellafante
18.01.2019, 14:42
This evening i'll try to update my profilux.

Inviato dal mio SM-N950F utilizzando Tapatalk

rocco bellafante
18.01.2019, 19:31
I tried to update , Now i'm at 7.15 but i can not choose the stirrer model yet...

Any suggestion?

Inviato dal mio SM-N950F utilizzando Tapatalk

PIWAWT
18.01.2019, 20:24
Which version does your GHLContolCenter have? Have you tried the expert mode?

Regards Pit

rocco bellafante
18.01.2019, 20:51
The version is 1.1.1.7 date : 19.7.2018
I use Expert mode on gcc

Inviato dal mio SM-N950F utilizzando Tapatalk

PIWAWT
18.01.2019, 22:35
Please use the Firmware V716 and the GHLControlCenter_V1118
Download (https://www.aquariumcomputer.com/downloads/ghl-control-center-v1-1-1-8/#)

New in V1.1.1.8:

Support for newer magnetic stirrer model (V2) for ProfiLux 3 (with included firmware 6.38), ProfiLux 4 (with included firmware 7.16) and GHL Doser 2/2.1/Maxi Slave/Standalone (with included firmware 1.30)

Sockets/switch channel Operating hour meter can be set for ProfiLux 4
regards Pit

rocco bellafante
18.01.2019, 22:58
Thanks a lot, some minutes ago i find in the forum a specific post. I update the gcc to 1.1.1.8 and then there is the column with model 1 or 2. Thanks a lot. Now it runs[emoji41][emoji41][emoji41]

Inviato dal mio SM-N950F utilizzando Tapatalk